Item List : | ||
| 417 Fontana Vialba (double set) | ||
| H=119cm W=128kg | ||
| 1x | 418 | Fontana Vialba (Bowl) |
| 1x | 419 | Fontana Vialba (Top part) |
| 1x | ??? | ?? Pump |
Materials Needed : | ||
| 3x 90'elbows 12mm | ||
| 2x M8 Rawbolts | ||
| 2x M8x120mm Fisher plugs | ||
| Hosepipe | ||
Tools Needed : | ||
| Hammer | ||
| Angle Grinder | ||
| Hammer Drilling Machine | ||
| 8mm Masonary Drill Bit | ||
| 14mm Masonary Drill Bit | ||
| Spirit Level | ||
-
Thank-you for purchasing a Gardens of Italy quality product. We would like to make installation as easy as possible for you with this installation pamphlet, so that you can enjoy this magnificent water feature in your own setting.
- Using a spirit level find the correct height and suitability for setting up this fountain.
- Grind a slot in the wall the length from the hole in the Fontana Vialba bowl (418) to the spout in the Fontana Vialba Top part (419).
- Place the hosepipe in the slot and at each end attach a 90'elbow.
- Place the Vialba bowl (418) against the wall and fasten to the wall with the M8 rawbolts.
- At the spout in the Vialba bowl (418) attach another 90'elbow.
- Place Vialba top part (419) onto Vialba bowl (418). It is not necessary to cement the two together unless there is a gap in between.
- Fasten Vialba top part (419) onto the wall using the fisher plugs. Drill a hole on either side of the spout, using a 8mm drill bit. Countersink the holes +-5mm deep using the 14mm drill bit. Insert the fisher plugs using a hammer but ensure that towards the end a screwdriver is used so as not to damage the plaque.
- In the Vialba bowl (418) place the pump. Once the pump wire has been connected up fill the bowl with water and turn on.