Installation: Fontana Oceano (4 Piece) (Item no 604)


click

Item List :

604 Fontana Oceano (4 Piece)
1x605Fontana Oceano Top Part
1x606Fontana Oceano Basin
1x607Fontana Oceano Backpiece
1x608Fontana Oceano Platform
1x913Waterfall 700 Pump

Materials Needed

Plastersand and cement
3x 90'elbows 12mm
2x M8x100mm Fisher plugs
1,3m Hosepipe

Tools Needed :

8mm Drill Bit
14mm Drill Bit
Spirit Level
Hammer
Drilling Machine
Angle Grinder

    Thank-you for purchasing a Gardens of Italy quality product. We would like to make installation as easy as possible for you with this installation pamphlet, so that you can enjoy this magnificent water feature in your own setting.

      Installation :

    1. First lay Oceano Platform (608) on level ground.
    2. Place Oceano Backpiece (607) ontop of the platform against the wall - at the same time establish the centre of the fountain.
    3. Once the centre has been found remove Oceano Backpiece (607) off the platform.
    4. Grind a slot into the wall making sure the slot starts just below Oceano Backpiece (607) up until the spout.
    5. Put your Oceano Backpiece (607) back onto the Oceano Platform (608) (it is not necessary to cement the two together).
    6. Make a slot about 20mm x 20mm where the Oceano Basin (606) and the Oceano Top part (605) join, to allow for the pipe to run through.
    7. Once slot made, place Oceano Basin (606) and Oceano Top part (605) together.
    8. Put the hosepipe through the slot, connecting to the elbows at each end.
    9. Pull the piping through the spout and once again attach an elbow to the end of the hosepipe.
    10. The Waterfall pump (913) sits inside the Oceano Basin (606). Connect the hosepipe to the pump.
    11. To make sure the Oceano Top part (605) stands firm, fisher plugs can be used. Drill 8mm holes on either side of the Oceano Top part (605). Using a 14mm drill bit countersink your 8mm holes about 5mm deep. Insert your fisher plugs using a hammer (make sure the last bit of your fisher plug you don't knock in with a hammer but use a screwdriver).


      Please also look at the Installation Diagram for help!