Installation: Fontana Fabrizia with Murale Halfdam (Item no 466)
Item List : |
| 466 Fontana Fabrizia |
| H =110cm Weight =390kg |
| 1x | 427 | Fontana Murale (halfdam) |
| 1x | 416 | Fontana Fabrizia |
| 1x | 913 | Waterfall 700 Pump |
Materials Needed : |
| 3x 90'elbows 12mm |
| 2x M8x120MM Fisher Plugs |
| Hosepipe |
Tools Needed : |
| Hammer |
| Angle Grinder |
| Hammer Drilling Machine |
| 8mm Masonary Drill Bit |
| 14mm Masonary Drill Bit |
Thank-you for purchasing a Gardens of Italy quality product. We would like to make installation as easy as possible for you with this installation pamphlet, so that you can enjoy this magnificent water feature in your own setting.
Installation :
- Place Fontana Murale (halfdam) (427) on the floor against the wall.
- The electrical connecting box must be situated near to the dam. The Waterfall pump (913) must be placed in the halfdam and the pump wire must be fed through the hole in the bottom of the dam (427), allowing for enough slack, and then silicone
seal around the hole.
- Find the centre of the dam and grind a slot in the wall, from the top of the dam, to the spout on the Fabrizia (416).
- Place hose piping into the slot and on each end attach a 90'elbow. Where the halfdam (427) and Fontana Fabrizia (416) join, another elbow must be attached.
- Place Fontana Fabrizia (416) ontop of Fontana Murale (halfdam) (427).
- Use fisher plugs to secure the top part onto the wall. On either side of the spout drill holes using a 8mm drill bit. Countersink the holes +-5mm deep using a 14mm drill bit. Insert the fisher plugs using a hammer, until near towards the end, use a screwdriver so as not to damage the plaque.
- Attach hosepipe to Waterfall pump (913).
