Item List: | ||
| 187 Fontana a Due Cadute | ||
| 1x | 70 | Dam for fountain |
| 1x | 188 | Base Attilio |
| 1x | 7 | Tre Cadute Medium Layer |
| 1x | 6 | Tre Cadute Small Layer |
| 1x | 34 | Boy with Fish (small rim) |
| 1x | 903 | Waterfall Pump 1500 |
Materials Needed | ||
| Hose Pipe 1,5mx12mm Diameter | ||
| Wooden Wedges | ||
| Plastersand and cement | ||
| 250ml White PVA Paint(Dulux) | ||
| Small Tube of Silicone Sealant | ||
| 1x12mm Elbow | ||
Tools | ||
| Spirit Level | ||
| Trowel | ||
| Paint Brush | ||
-
Thank-you for purchasing a Gardens of Italy quality product. We would like to make
installation procedures as easy as possible for you with this installation pamphlet,
so that you can enjoy this mangnificent water feature in your own setting.
- Place Dam for Fountain (70) on level ground.
- Place Base Atilio (188) in the middle of the dam and remove the cheescake segments.
- Install the pump (903) and push the hose through the hole at the top of the base, making sure it extends 100mm.
- Cement the Tre Cadute Medium Layer (7) to the Base Attilio (188), using the wooden wedges to ensure it is level. Push the hose through again making sure it extends above the top.
- Cement the Tre Cadute Small Layer (6) to Tre Cadute Medium Layer (7), using the wooden wedges to ensure it is level. Push the hose through again making sure it extends above the top.
- When placing the boy with fish (34) the hose should only extend up to a third into the height of the boy. The hose should also be silicone sealed on the inside to prevent backflow of water down inside of the fountain. The boy can then be cemented in place.
- After the mix has set, the wedges can be removed and the holes can then be plastered over. The cemented joints can now be smoothed down and wrapped in wet sponge or felt and plastic to aid the curing process. This wrapping should be left on for 24 hours, after which the joints can be painted over.