Item List : | ||
| 609 Fontana Concordia (No Face) | ||
| 1x | 611 | Fontana Concordia Top Part |
| 1x | 612 | Fontana Concordia Basin |
| 1x | 913 | Waterfall 700 Pump |
OR : | ||
| 630 Fontana Concordia (With Face) | ||
| 1x | 612 | Fontana Concordia Basin |
| 1x | 614 | Fontana Concordia Top Part (with face) |
| 1x | 913 | Waterfall 700 Pump |
Materials Needed : | ||
| Plastersand and cement | ||
| 3x 90'elbows 12mm Diameter | ||
| 2x M8x100mm Fisher Plugs | ||
| 1.3m Hosepipe | ||
Tools needed : | ||
| 8mm Drill Bit | ||
| 14mm Drill Bit | ||
| Spirit Level | ||
| Hammer | ||
| Hammer Drilling Machine | ||
| Angle Grinder | ||
-
Thank-you for purchasing a Gardens of Italy quality product. We would like to make installation as easy as possible for you with this installation pamphlet, so that you can enjoy this magnificent water feature in your own setting.
- Firstly make sure your fountain is going to stand on level ground.
- Find the centre of the fountain in order to establish where the slot must be grinded into the wall.
- Grind a slot into the wall making sure the slot starts just below the top of the Concordia Basin (612) upto the spout found on the rosette/face.
- Once the slot is made place Concordia Top part (611/614) onto Concordia Basin (612) and cement together.
- Put the hosepipe through the slot, connecting to the elbows at each end.
- Pull the hosepipe through the spout and once again attach an elbow to the end of the hosepipe.
- You then need to drill 8mm holes on either side of the rossette / face of the Concordia Top part (611/614).
- Using a 14mm drill bit you can countersink your 8mm holes +/- 5mm deep.
- Insert your fisher plugs using your hammer. Ensure not to knock them completely in the last bit you can use a screwdriver to secure the fisher plugs.
- The Waterfall pump sits inside the Concordia Basin (612) and is connected to the hosepipe.