Installation: Fontana Anzio (5 parts) (Item no 788)
    click

    Item List

    788 Fontana Anzio
    H=134cm W=41cm Dia=0cm
    Depth=41cm Weight=186kg
    1x726Pigna Anzio
    1x784Small Layer Anzio
    1x785Medium Layer Anzio
    1x786Big Layer Anzio
    1x787Door for Base Anzio
    1x903Waterfall 1500 Pump

    Materials Needed

    Hosepipe 20mmx1.6m
    1 Tube Silicone Sealant
    6 Wooden Wedges 10x50mm
    Plastersand and Cement
    250ml White Pva Paint

    Tools

    Trowel
    Spirit Level
    Paint Brush

      Thank-you for purchasing a Gardens of Italy quality product. We would like to make installation as easy as possible for you with this installation pamphlet, so that you can enjoy this magnificent water feature in your setting.

        Installation

      1. Place Big Layer Anzio (786) in dam. Please refer to installation of Dam Monaco (16-parts) or refer to installation of Dam Arcara 16-parts(Plain Coping) or refer to installation of Dam Positano 12-parts(Plain Coping) Can also be used with Damring Sicilia (with floor)
      2. Position hosepipe through hole in Big Layer Anzio (786). Seal off with silicone sealant.
      3. Slide Medium Layer Anzio (785) over hosepipe ontop of Big Layer Anzio. Level with wooden wedges.
      4. Slide Small Layer Anzio (784) over hosepipe ontop of Medium Layer Anzio. Level with wooden wedges.
      5. Slide Pigna Anzio (726) over hosepipe and place on top of Small Layer Anzio (784). Cut off excess hosepipe and seal off edges between Pigna Anzio and hosepipe with Silicone Sealant to prevent backflow.
      6. Connect pump to the hose and position in Base. Put Door for Base (787) in recess. (Make sure hosepipe is not bent, otherwise will interrupt water flow). Ensure electrical connections are correctly waterproofed - consult an electrician for advice.
      7. Wait 24hrs to let Sealant set before using the fountain. Fill water into fountain and switch on pump. Observe cascading of water. Move wedges until water flows evenly from all sides. Switch off pump and remove water from fountain. Put cement in between wedges. When cement is dry, remove wedges and fill void.
      8. Paint over cement using antique method.
      9. After cement has dried, fill with water - now ready to use.


        Please also look at the Installation Diagram for help!