Installation: Fontana Amalfi Set (Item no 590)
    click

    Item List

    590 Fontana Amalfi
    1x591Putto Amalfi
    1x624Pumphousing large with cover
    1x587Fontana Agrigento Big Bowl
    1x588Fontana Agrigento Base Cover
    1x589Fontana Agrigento Base
    1x903Waterfall 1500 Pump

    Materials Needed

    1,5m Hosepipe 20mm Diameter
    250ml White PVA Paint
    Conduit Pipe
    Small Tube of Silicone Sealant
    Plastersand and Cement

    Tools Needed :

    Spirit Level
    Paint Brush

      Thank you for purchasing a Gardens of Italy quality product. We would like to make installation as easy as possible for you with this installation pamphlet, so that you can enjoy this magnificent water feature in your own setting.

      Installation :

    1. For this fountain a waterproofing connection box must be placed as close as possible to the outside base. With the help of a qualified electrician, a conduit pipe must be from this box to the electrical point.
    2. Remember the ground must be compacted to make sure the fountain stands level.
    3. Cement the Agrigento Big bowl (587) onto the Agrigento Base (589) making sure it is level.
    4. Feed the pump wire through the big bowl and base leaving enough slack +/- 10-20cm and then silicone seal at both top an bottom. Place the pumphousing (624) over the pump.
    5. On the outlet of the Waterfall pump (903) attach the hose.
    6. Then feed hose pipe through the Putti Amalfi (591). It should stick out at the top.
    7. Put umbrella on top of Putti, cement the umbrella down, cut off hose flush to top of umbrella. Silicone seal around the pipe on top of umbrella to prevent backflow of water running into fountain.
    8. Do not use fountain for 24 hours, until silicone and cement are set completely.


      Please also look at the Installation Diagram for help!